No.1 Zhongxing Road in Xinzheng City, Henan, China.
Tel:+86-371-55982206
Fax:+86-371-65613933
Laboratory mixer repair and maintenance Notice
Time 2024-04-03 Browsing times 次
Laboratory Mixer work maintenance should pay attention to the following matters:
1,We must according to the operation of the equipment, the operation of the equipment, which is the best equipment for the maintenance of dry powder mixer.
2, Attention to the device to start the normal and then feeding mix, feeding should be slow to join the required order.
3, Be careful the sealing ring, the coupling with rubber ring, V belt and rolling bearings, these parts of the work parts easy to failure, if necessary, should be replaced in time.
4, Regular (usually a quarter) check whether the loosening of the fastener; the Department of cleaning equipment, dust removal.
The maintenance of a new type of dry powder mixer can be carried out in a year. The following points should be noted:
1.The scraper and the mixing chamber wall gap should meet the requirements of 1, inspection, dressing agitator.
2, Remove the rolling bearing, cleaning and inspection; serious wear parts replacement; replacement of grease and seal ring.
3, Check whether the main shaft bending or wear phenomenon.
4, Check the cleaning cylinder, replace the sealing ring and the guide sleeve parts, check whether the piston rod bending deformation and wear phenomena.
5, The main parts inspection after the record, when necessary test, ready to put the next parts, repair and replacement.
