Traditional 3D Mixing Machine's Disadvantages
Time 2024-04-03 Browsing times 次
Comapred with new developed JINHE Double Movement Mixer,there may be some following problems
when Traditional 3D mixing machine in work:
3D mixing machine is the most taboo in the material mixing in the presence of centrifugal force, a
mixture of movement, it can make different density is mixed materials generated segregation; be mixed
material into a mass movement and accumulation, is the diffusion of admixture material cannot be
effective, dimensional motion mixing machine motion state of the ills of the customer service.
Three dimensional mixer reducer should be every three months for new oil once, often use. The replace-
ment should be cleaned with new oil reducer.
Check parts of worm and worm wheel, bearing, oil seal, mechanical regular monthly check 1-2 time. The operation part is flexible, fasteners, abnormal situation should be timely treatment.
The three-dimensional mixing machine in operation, due to the mixing barrel with multi direction
movement, so all kinds of materials in the mixing process, the speed of the flow and diffusion, while
avoiding and accumulation of general mixed machine caused by the centrifugal force of gravity
segregation of mixed materials, no dead angle, can effectively ensure the best quality of the mixed
material the. This machine mixing tube of two spatial cross and vertical to each other, respectively
between connected by the 3D motion of rocker arm driving shaft and a driven shaft, mixing cylinder
comprises a cylinder body, a positive cone feeding end, eccentric cone discharging end, a feeding
hole and a discharge device.
If found abnormal machine vibration or issue abnormal sound, the use of the process. Should
immediately stop check.
Find the fault should be repaired in a timely manner. Electric control parts shall be kept clean sensitive.
Should be light, stable installation, disassembly with care, to avoid deformation and damage of stirring
paddle assembly and disassembly.
Should the residual material of each part of the brush Jing machine, after use. Three dimensional mixer
dispersion machine mixer mixer emulsifying machine dispersion machine stop time is long, the machine
must be full wipe clean parts surface coated with anti rust oil, with a tarpaulin cover good.
The core components of three dimensional mixer is mixing tube, discharge, the discharge port is at the
lowest position of the mixing container, and material as.
Together at three-dimensional mixer mixing two barrel of a spatial cross and vertical to each other,
respectively between connected by the 3D motion of rocker arm driving shaft and a driven shaft, mixing
cylinder comprises a cylinder body, a positive cone feeding end, eccentric cone discharging end, a
material inlet and discharging device composed of three-dimensional mixing machine.
There are many disadvantages that traditional 3D mixing machine have,while JINHE double movement
mixer can overcome.
